Conditions for Setting the DTC

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.

If the gear shift is not in progress and the selector lever position is "1", "2", "3", "D" or "Z3" and the transaxle output speed is less than the limit value of transaxle output speed for plausibility check of transaxle output speed and the turbine speed is greater than the limit value of turbine speed for plausibility check of transaxle output speed then the error bit will be set.
System voltage is greater than 7 V.
Engine is running.
No input speed error DTCs P0715, P0716 and P0717.
No transaxle range sensor error DTC P0705.
TCM or ECM is defective.
Immediately after the above condition occurs.