Caliper Overhaul Disassembly and Assembly: Disassembly

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.

Remove the caliper assembly. Refer to Caliper Assembly Removal and Installation .
Remove the caliper guide pin that connects the caliper piston housing to the retaining frame.

Fig 1: Caliper Guide Pin
Courtesy of SUZUKI OF AMERICA CORP.
Remove the front brake pad set, including the pad springs, from the caliper. Refer to Brake Pads Removal and Installation .

Fig 2: Front Brake Pad Set And Pad Springs
Courtesy of SUZUKI OF AMERICA CORP.
Using compressed air, blow out the piston from housing, and remove the outer piston seal.

Fig 3: Blowing Compressed Air And Removing Outer Piston Seal
Courtesy of SUZUKI OF AMERICA CORP.
Remove the inner seal.

Fig 4: Removing Inner Piston Seal
Courtesy of SUZUKI OF AMERICA CORP.
Remove the bleeder valve protector and the bleeder valve.

Fig 5: Bleeder Valve Protector And Bleeder Valve
Courtesy of SUZUKI OF AMERICA CORP.