Stabilizer Shaft and Insulators Removal and Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.

Install the stabilizer shaft.
Install the stabilizer shaft insulator clamps, the stabilizer shaft clamp bolt, and the insulators onto the crossmember. Do not tighten the bolt.

Fig 1: Identifying Stabilizer Shaft-To-Crossmember Clamp Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Install the stabilizer link onto the stabilizer shaft and connect them with the stabilizer shaft-to-stabilizer link nut.
Tighten:
- Tighten the stabilizer shaft-to-stabilizer link nut to 47 N.m (35 lb-ft).
- Tighten the stabilizer shaft-to-crossmember clamp bolts to 25 N.m (18 lb-ft).
Install the front wheels. Refer to WHEEL REMOVAL AND INSTALLATION .

Fig 2: Identifying Stabilizer Shaft-To-Stabilizer Link Nut
Courtesy of SUZUKI OF AMERICA CORP.