LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Engine Electrical Devices) >> Engine Electrical Devices >> Crankshaft Position (CKP) Sensor Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position (CKP) Sensor Removal and Installation: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the power steering pump, if equipped. Refer to PUMP ASSEMBLY REMOVAL AND INSTALLATION .
  3. Remove the A/C compressor. Refer to COMPRESSOR REMOVAL AND INSTALLATION .
  4. Remove the rear A/C compressor mounting bracket bolts and the rear A/C compressor mounting bracket.
  5. Remove the accessory mounting bracket by removing the bolts.
    Fig 1: Accessory Mounting Bracket Bolts
    G04716378Courtesy of SUZUKI OF AMERICA CORP.
  6. Disconnect the Crankshaft Position (CKP) sensor connector.
  7. Remove the CKP sensor retaining bolt.
  8. Gently rotate and remove the CKP sensor from the engine block.
    Fig 2: CKP Sensor And Retaining Bolt
    G04716379Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals