Crankshaft Position (CKP) Sensor Removal and Installation: Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
- Insert the CKP sensor into the engine block.
- Install the CKP sensor retaining bolt.
Tighten:
Tighten the crankshaft position sensor retaining bolt to 8 N.m (71 lb-in).
- Connect the CKP sensor connector.
- Install the accessory mounting bracket with the bolts.
- Install the rear A/C mounting bracket.
Tighten:
Tighten the rear A/C mounting bracket bolts to 35 N.m (26 lb-ft).
- Install the A/C compressor. Refer to COMPRESSOR REMOVAL AND INSTALLATION .
- Install the power steering pump. Refer to PUMP ASSEMBLY REMOVAL AND INSTALLATION .
- Connect the negative battery cable.
Tighten:
Tighten the accessory mounting bracket bolts to 37 N.m (27 lb-ft).