LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Instrumentation/Driver Info./Horn) >> Diagnostic Information & Procedures >> Chime Module Diagnosis >> Key Reminder Chime Inoperative
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Key Reminder Chime Inoperative

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
KEY REMINDER CHIME DIAGNOSIS PROCEDURE

Step Action Value(s) Yes No
1 Check the chime module connector to make sure it is connected properly.
Is the connector disconnected or partially disconnected?		 - Go to Step 2 Go to Step 3
2 Connect the electrical connector for the chime module.
Is the repair complete?		 - System OK -
3 Check fuse Ef19.
Is fuse Ef19 blown?		 - Go to Step 4 Go to Step 5
4
  1. Check for a short circuit and repair it, if necessary.
  2. Replace the fuse.

Is the repair complete?		 - System OK -
5
  1. Turn the ignition ON.
  2. Check the voltage at fuse Ef19.

Is the specified voltage available at fuse Ef19?		 11 - 14V Go to Step 7 Go to Step 6
6 Repair the power supply circuit for fuse Ef19.
Is the repair complete?		 - System OK -
7
  1. Disconnect the chime module.
  2. Check the voltage at terminal 2 of the chime module connector.

Does the voltage equal the specified value?		 11 - 14V Go to Step 13 Go to Step 8
8
  1. Disconnect the key reminder switch.
  2. Use an ohmmeter to check the continuity between the key reminder switch and fuse Ef19.

Does the ohmmeter indicate the specified value?		 0 Ω Go to Step 10 Go to Step 9
9 Repair the open circuit between the key reminder switch and fuse Ef19.
Is the repair complete?		 - System OK -
10 With the key reminder switch and the chime module disconnected, check the continuity between the key reminder switch and terminal 2 of the chime module connector.
Does the ohmmeter indicate the specified value?		 0 Ω Go to Step 12 Go to Step 11
11 Repair the open circuit between the key reminder switch and terminal 2 of the chime module connector. - System OK -
12 Replace the key reminder switch.
Is the repair complete?		 - System OK -
13 With the chime module disconnected, use an ohmmeter to check continuity between terminal 5 of the chime module connector and ground.
Does the ohmmeter indicate the specified value?		 0 Ω Go to Step 15 Go to Step 14
14 Repair the open circuit between terminal 5 of the chime module connector and ground.
Is the repair complete?		 - System OK -
15 Replace the chime module.
Is the repair complete?		 - System OK -
scientia non olet · About LEMON Manuals