LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 47 (Instrumentation/Driver Info./Horn) >> Diagnostic Information & Procedures >> Chime Module Diagnosis >> Door-Open Warning Chime Inoperative
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Door-Open Warning Chime Inoperative

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
DOOR-OPEN WARNING CHIME DIAGNOSIS PROCEDURE

Step Action Value(s) Yes No
1 Check the chime module connector to make sure it is connected properly.
Is the connector disconnected or partially disconnected?		 - Go to Step 2 Go to Step 3
2 Connect the electrical connector for the chime module.
Is the repair complete?		 - System OK -
3 Check fuse F4.
Is fuse F4 blown?		 - Go to Step 4 Go to Step 5
4
  1. Check for a short circuit and repair it, if necessary.
  2. Replace the fuse.

Is the repair complete?		 - System OK -
5
  1. Turn the ignition ON.
  2. Check the voltage at fuse F4.

Is the specified voltage available at fuse F4?		 11 - 14V Go to Step 7 Go to Step 6
6 Repair the power supply circuit for fuse F4.
Is the repair complete?		 - System OK -
7
  1. Disconnect the chime module.
  2. Turn the ignition ON.
  3. Check the voltage at terminal 8 of the chime module connector.

Does the voltage equal the specified value?		 11 - 14V Go to Step 9 Go to Step 8
8 Repair the open circuit between fuse F4 and the chime module connector.
Is the repair complete?		 - System OK -
9 With the chime module disconnected, use an ohmmeter to check the continuity between terminal 5 of the chime module connector and ground.
Does the ohmmeter indicate the specified value?		 0 Ω Go to Step 11 Go to Step 10
10 Repair the open circuit between terminal 5 of the chime module connector and ground.
Is the repair complete?		 - System OK -
11
  1. Disconnect the chime module connector.
  2. Make sure the driver's side door is open.
  3. Use an ohmmeter to check the continuity between terminal 4 of the chime module and ground.

Does the ohmmeter indicate the specified value?		 0 Ω Go to Step 12 Go to Step 13
12 Replace the chime module.
Is the repair complete?		 - System OK -
13
  1. Disconnect the front door contact switch.
  2. Use an ohmmeter to check the continuity between the door contact switch and terminal 4 of the chime module.

Does the ohmmeter indicate the specified value?		 0 Ω Go to Step 15 Go to Step 14
14 Repair the open circuit between the door contact switch and terminal 4 of the chime module.
Is the repair complete?		 - System OK -
15 Replace the door contact switch.
Is the repair complete?		 - System OK -
scientia non olet · About LEMON Manuals