Conditions for Setting the DTC

WARNING: This page is about a different car, the 2005 Suzuki Reno and 2005 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.

If the gear shift is not in progress and the selector lever position is "1", "2", "3", "D", or "Z3" and the transaxle output speed is less than the limit value of transaxle output speed for plausibility check of transaxle output speed and the turbine speed is greater than the limit value of turbine speed for plausibility check of transaxle output speed then the error bit will be set.
System voltage is greater than 7 volts.
Engine is running.
No input speed error DTCs P0715, P0716, and P0717.
No transmission range sensor error DTC P0705.
TCM or ECM is defective.
Immediately after the above condition occurs.