LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (Steering Wheel And Column) >> Repair Instructions >> Steering Wheel Rotation Sensor Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Wheel Rotation Sensor Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Suzuki Reno and 2005 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the upper and the lower instrument trim panels. Refer to "INSTRUMENT CLUSTER TRIM PANEL REMOVAL AND INSTALLATION :".
  3. Disconnect the steering wheel rotation sensor electrical connector.
    Fig 1: Disconnecting Steering Wheel Rotation Sensor Electrical Connector
    G04103919Courtesy of SUZUKI OF AMERICA CORP.
  4. Remove the intermediate shaft from the steering column to allow removal of the steering wheel rotation sensor. Refer to "INTERMEDIATE SHAFT AND DASH SEAL REMOVAL AND INSTALLATION :".
  5. Remove the retaining screw from the steering wheel rotation sensor.
  6. Remove the steering wheel rotation sensor.
    Fig 2: Removing Retaining Screw From Steering Wheel Rotation Sensor
    G04103920Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals