Driver Air Bag (Inflator) Module Removal and Installation: Installation

WARNING: This page is about a different car, the 2008 Suzuki Grand Vitara, 2007 Suzuki Grand Vitara, and 2006 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.

Reference: DRIVER AIR BAG (INFLATOR) MODULE INSPECTION:ADVANCED AIR BAG

Connect driver air bag (inflator) module connector (1) to driver air bag (inflator) module (2) securely as shown in the figure.
1. Connect connector.
2. Lock connector with lock button (3).
  
  Fig 1: Connecting Driver Air Bag (Inflator) Module Connector To Driver Air Bag (Inflator) Module
  Courtesy of SUZUKI OF AMERICA CORP.
Install driver air bag (inflator) module (1) to steering wheel (2), taking care so that no part of wire harness is caught between them.
Make sure that clearance between module (1) and steering wheel (2) is uniform all the way.
Tighten left side bolt (3) of driver air bag (inflator) module first and then right side bolt (4).
Tightening torque

Driver air bag (inflator) module mounting bolt a: 9 N.m (0.9 kg-m, 6.5 lb-ft)
Install steering wheel side caps (5).

Fig 2: Identifying Steering Wheel Side Caps
Courtesy of SUZUKI OF AMERICA CORP.
Enable air bag system. Refer to ENABLING AIR BAG SYSTEM:ADVANCED AIR BAG .
Connect negative (-) cable at battery.