Contact Coil Cable Assembly Removal And Installation: Installation

WARNING: This page is about a different car, the 2008 Suzuki Grand Vitara, 2007 Suzuki Grand Vitara, and 2006 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.

Reference: CONTACT COIL CABLE ASSEMBLY INSPECTION

Reference: CENTERING CONTACT COIL CABLE ASSEMBLY

Check to make sure that vehicle's front tires are set at straight-ahead position and then ignition switch is at "LOCK" position.
Install contact coil cable assembly to steering column.
NOTE: New contact coil cable assembly is supplied with contact coil cable assembly set and held at its center position with a lock pin (1). Remove this lock pin after installing contact coil cable assembly to steering column.

Fig 1: Identifying Lock Pin
Courtesy of SUZUKI OF AMERICA CORP.
Connect all connectors that have been removed in "Removal".
Install steering column upper cover (2) and lower cover (3), and then tighten steering column cover screws (1).
CAUTION: When installing lower cover (3) and upper cover (2), be careful so that each lead wire is not caught between covers.

Fig 2: Identifying Upper & Lower Cover With Steering Column Cover Screws
Courtesy of SUZUKI OF AMERICA CORP.
Install steering column hole cover (1).

Fig 3: Identifying Steering Column Hole Cover
Courtesy of SUZUKI OF AMERICA CORP.
Install steering wheel to steering column. Refer to STEERING WHEEL REMOVAL AND INSTALLATION .