Heated Oxygen Sensor (Sensor-2) Removal And Installation: Installation
WARNING: This page is about a different car, the 2008 Suzuki Grand Vitara, 2007 Suzuki Grand Vitara, and 2006 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.
Reverse removal procedure noting the following.
- Tighten oxygen sensor to specified torque.
Tightening torque
Heated oxygen sensor a: 45 N.m (4.5 kg-m, 32.5 lb-ft)
- Connect connector of oxygen sensor and clamp wire harness securely.
- After installing oxygen sensor, start engine and check that no exhaust gas leakage exists.