Rear Shock Absorber Removal And Installation: Installation
WARNING: This page is about a different car, the 2008 Suzuki Grand Vitara, 2007 Suzuki Grand Vitara, and 2006 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.
Install shock absorber by reversing removal procedure, noting the following instructions.
- Tighten all fasteners to specified torque.
Tightening torque
Shock absorber upper bolt a: 60 N.m (6.0 kg-m, 43.5 lb-ft)
Shock absorber lower bolt b: 90 N.m (9.0 kg-m, 65.0 lb-ft)
Wheel nut: 100 N.m (10.0 kg-m, 72.5 lb-ft)
CAUTION:
- If reuse shock absorber bolts, apply engine oil to thread, bearing and trunk surface.
- Shock absorber bolts must be tightened in non-loaded condition.