Clutch Coil Removal
WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.
Tools Required:
J-8433-1 Puller Crossbar
J-8433-3 Forcing Screw
J-33023-A Puller Pilot
J-33024 Clutch Coil Installer Adapter
J-33025 Clutch Coil Puller Legs
J-34992 Compressor Holding Fixture
- Disconnect the negative battery cable.
- Recover the refrigerant. Refer to Discharging, Adding Oil, Evacuating and Charging Procedures for A/C System .
- Remove the compressor. Refer to Compressor Removal .
- Remove the clutch plate and hub assembly. Refer to Clutch Plate and Hub Assembly Disassembly .
- Remove the clutch rotor and bearing. Refer to Clutch Rotor and Bearing Disassembly .
- Mark the clutch coil terminal location on the compressor housing.
- Install the puller pilot J-33023-A on the compressor housing. Also install the puller cross bar J-8433-1 with the clutch coil puller legs J-33025.
- Tighten the forcing screw J-8433-3 against the puller pilot J-33023-A to remove the clutch coil.