Temperature Door Motor Removal

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the glove box lower panel cover. Refer to GLOVE BOX REMOVAL .
Disconnect the electrical connector.
Remove the actuating rod by snapping it out of the lever with needle-nose pliers.

Fig 1: Identifying Temperature Door Motor Actuating Rod
Courtesy of SUZUKI OF AMERICA CORP.
Remove the motor lever from its shaft by pulling the lever off.
Remove the motor retaining screws.
Remove the temperature door motor.

Fig 2: Identifying Temperature Door Motor & Retaining Screws
Courtesy of SUZUKI OF AMERICA CORP.