Temperature Cable Removal and Installation: Removal

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
The heater/air distribution case linkage also cannot be adjusted.
Disconnect the cable retainer from the blower housing.
Slide the cable eyelet off the post on the temperature door lever.

Fig 1: Identifying Blower Housing, Cable Retainer And Temperature Door Lever
Courtesy of SUZUKI OF AMERICA CORP.
Remove the audio system trim plate. Refer to INSTRUMENT CLUSTER TRIM PANEL REMOVAL .
Remove the 4 controller retaining screws.
Pull out the controller to provide clearance for removal of the temperature control cable.
Disconnect the temperature control cable eyelet from the post on the controller.
Snap the cable housing connector out of the slide position on the controller.

Fig 2: Identifying Temperature Control Cable Eyelet
Courtesy of SUZUKI OF AMERICA CORP.