LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Heater And Ventilation) >> Repair Instructions >> Temperature Cable Removal and Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Temperature Cable Removal and Installation: Installation

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the temperature control cable eyelet to the post on the controller.
  2. Snap the cable housing connector to the slide position on the controller.
    Fig 1: Identifying Temperature Control Cable Eyelet
    G04720763Courtesy of SUZUKI OF AMERICA CORP.
  3. Gently insert the controller into position on the center console.
  4. Install the 4 controller retaining screws.

    Tighten: 

    Tighten the controller retaining screws to 4 N.m (35 lb-in.).

  5. Install the temperature control cable eyelet to the post on the temperature door lever.
  6. Snap the cable retainer to the blower housing.
    Fig 2: Identifying Blower Housing, Cable Retainer And Temperature Door Lever
    G04720762Courtesy of SUZUKI OF AMERICA CORP.
  7. Move the temperature control to verify the smooth operation and function of the door and the cable.
  8. Install the instrument cluster trim panel. Refer to INSTRUMENT CLUSTER TRIM PANEL INSTALLATION .
  9. Connect the negative battery cable.
  10. Operate the heating and cooling systems to verify proper function.
  11. Install the glove box. Refer to GLOVE BOX INSTALLATION .
    Fig 3: Identifying Temperature Control System Trim Plate
    G04720766Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals