Brake Hose Front Installation

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.

Install the new disc brake hose to the caliper with the new seal rings and the bolt.
Tighten:

Tighten the front disc brake hose-to-caliper bolt to 40 N.m (30 lb-ft).
Connect the brake hose at the steering knuckle shaft bracket and install the retainer.

Fig 1: Identifying Brake Hose And Wheel Housing Bracket
Courtesy of SUZUKI OF AMERICA CORP.
Connect the brake line to the brake hose on the wheel housing bracket on each side of the vehicle and install the retainer.
Tighten:

Tighten the brake line fittings to 16 N.m (12 lb-ft).
Lower the vehicle.
Bleed the brake system. Refer to Manual Bleeding the Brakes .
Check the brake system for leaks.