LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Standard >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine General Information And Diagnosis >> Diagnostic Information and Procedures >> MIL Remains ON after Engine Starts >> Troubleshooting
April 5, 2026: LEMON Manuals is launched! Read the announcement.

MIL Remains ON after Engine Starts: Troubleshooting

NOTE: When measuring circuit voltage, resistance and/or pulse signal at ECM connector, connect the special tool to ECM and/or the ECM connectors referring to INSPECTION OF ECM AND ITS CIRCUITS .
TROUBLESHOOTING CHART

Step Action YES NO
1  DTC check 
  1. Start engine and recheck DTC of ECM and TCM while engine running.

Is there any DTC(s)? 		 Go to Step 2 of ENGINE AND EMISSION CONTROL SYSTEM CHECK , Step 2 of A/T SYSTEM CHECK . Go to Step 2.
2  CAN communication line circuit check 
  1. Check CAN communication line circuit between combination meter and ECM, TCM, ABS / ESP® control module, 4WD control module, keyless start control module referring to Step 15 DTC U0073: CONTROL MODULE COMMUNICATION BUS OFF .

Is circuit in good condition? 		 Substitute a known-good combination meter and recheck. If MIL still remains ON, substitute a known-good ECM and recheck. Repair or replace CAN communication circuit.
scientia non olet · About LEMON Manuals