DTC Clearance
- Turn ignition switch to OFF position.
- Connect SUZUKI scan tool to data link connector (DLC) (1) located on underside of instrument panel.
(A): SUZUKI scan tool
- Turn ignition switch to ON position.
- Erase DTC according to instructions displayed on SUZUKI scan tool. Refer to SUZUKI scan tool operator's manual for further details.
- After completing clearance, turn ignition switch OFF and disconnect SUZUKI scan tool from data link connector (DLC).
- Perform DTC CHECK and confirm that NO CODES is displayed.NOTE: DTC stored in 4WD control module memory are also cleared in the following cases. Be careful not to clear them before keeping their record.
- When power to 4WD control module is cut off (by disconnecting battery cable, removing fuse or disconnecting 4WD control module connectors).
- When the same malfunction (DTC) is not detected again during 40 engine warm-up cycles.