Scan Tool Data: Notes
The parameter data below are values measured with the scan tool when the normally operating vehicle is under the following conditions. When taking measurements for comparison by using the scan tool, be sure to check that the vehicle is under the following conditions.
- Apply parking brake and block wheels.
- Ignition switch ON.
- Turn OFF air conditioner (if equipped).
- Apply no load to power steering (if equipped). (Don't turn it)
- Turn OFF all electric loads (except ignition).
- No DTC.
- ABS is not operated. (Normal braking operation)
SCAN TOOL DATA CHART
| Scan Tool Data | Standards | Condition | |
|---|---|---|---|
| Battery Voltage | 10.0 - 16.0 V | - | |
| Pump Motor Driver | 0.0 V | - | |
| RF Wheel Speed | 0 km/h, 0.0 MPH | Vehicle stop | |
| LF Wheel Speed | 0 km/h, 0.0 MPH | Vehicle stop | |
| RR Wheel Speed | 0 km/h, 0.0 MPH | Vehicle stop | |
| LR Wheel Speed | 0 km/h, 0.0 MPH | Vehicle stop | |
| Brake Switch | ON | Brake pedal depressed | |
| OFF | Brake pedal released | ||
| G sensor | 0.00G (4WD model) | Place vehicle on the level | |
| 2.54G (2WD model) | Place vehicle on the level | ||
| Solenoid Valve Power Supply Driver | ON | Ignition switch ON | |
| Inlet Solenoid | RF | OFF | Vehicle stop |
| LF | |||
| RR | |||
| LR | |||
| Outlet Solenoid | RF | OFF | Vehicle stop |
| LF | |||
| RR | |||
| LR | |||