Crossmember Assembly Installation

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.

Install the control arm onto the crossmember assembly. Refer to Control Arm Installation .
Tighten:

Tighten the stabilizer bar bolts and nuts to 50 N.m (37 lb-ft).
Install the crossmember bolts-to-control arm, nuts-to-longitudinal and crossmember.
Tighten:

Tighten the crossmember bolts-to-control arm and nuts-to-longitudinal. to 150 N.m (110 lb-ft).

Fig 1: Identifying Crossmember, Bolts-To-Control Arm & Nuts-To-Longitudinal
Courtesy of SUZUKI OF AMERICA CORP.
Install the out tie rod and control arm ball joint. Refer to OUTER TIE ROD INSTALLATION and Control Arm Installation .
Install the front exhaust pipe and centermember.

Fig 2: Identifying Outer Tie Rod And Control Arm Ball Joint
Courtesy of SUZUKI OF AMERICA CORP.
Install the steering interm shaft and bolt.
Tighten:

Tighten the steering interm shaft bolt to 25 N.m (18 lb-ft).

Fig 3: Identifying Steering Interm Shaft And Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install the power steering pipe union nuts.
Tighten:

Tighten the power steering pipe union nuts to 30 N.m (22 lb-ft).
Fill the power steering oil into the power steering system.

Fig 4: Identifying Shift Control Bracket
Courtesy of SUZUKI OF AMERICA CORP.