LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Air Conditioning System) >> Repair Instructions >> Receiver-Dryer Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Receiver-Dryer Removal and Installation: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Discharge and recover the refrigerant. Refer to Discharging, Adding Oil, Evacuating, and Charging Procedures for A/C System .
  3. Remove the condenser. Refer to Condenser Removal and Installation .
  4. Remove the receiver-dryer-to-condenser pipe block bolt.
    Fig 1: Identifying Receiver-Dryer-To-Condenser Pipe Block Bolt
    G04717814Courtesy of SUZUKI OF AMERICA CORP.
  5. Loosen the bolt that secures the receiver-dryer band clamp.
  6. Remove the receiver-dryer by sliding it up and out of the band clamp.
  7. Cap all open connections to prevent contamination.
  8. Drain the oil from the receiver-dryer into a graduated container. Record the amount of oil drained.
  9. Discard the used oil.
scientia non olet · About LEMON Manuals