Control Valve Assembly Removal and Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.

Coat all the O-rings with clean Polyalkaline Glycol (PAG) oil.
Push the control valve in place using thumb pressure.

Fig 1: Installing Control Valve Assembly
Courtesy of SUZUKI OF AMERICA CORP.
Use the snap ring pliers J-5403 to install the valve retaining ring. The high point of the curved sides must be against the valve housing. Be sure the retaining ring is properly seated in the ring groove.
Evacuate and recharge the A/C system. Refer to Discharging, Adding Oil, Evacuating, and Charging Procedures for A/C System .

Fig 2: Identifying Control Valve Assembly
Courtesy of SUZUKI OF AMERICA CORP.