LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (Air Conditioning System) >> Repair Instructions >> Compressor Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Compressor Removal and Installation: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Discharge and recover the refrigerant. Refer to Discharging, Adding Oil, Evacuating, and Charging Procedures for A/C System .
  3. Remove the discharge hose mounting nut.
  4. Lift the discharge hose mounting block and the suction hose from the compressor.
    Fig 1: Identifying Refrigerant Discharge Hose Block-To-Compressor Retaining Nut
    G04717789Courtesy of SUZUKI OF AMERICA CORP.
  5. Raise and suitably support the vehicle.
  6. Remove the engine under cover. Refer to ENGINE UNDER COVERS REMOVAL AND INSTALLATION .
  7. Remove the accessory drive belt.
    Fig 2: Removing Accessory Drive Belt
    G04717821Courtesy of SUZUKI OF AMERICA CORP.
  8. Disconnect electrical connector at the compressor.
  9. Remove the compressor bolts and nuts.
  10. Remove the compressor.
  11. Drain the oil from the compressor into a container. Measure the amount of the oil that is drained. Then discard the used oil.
    Fig 3: Identifying Compressor Mounting Bolts And Nuts
    G04717822Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals