Clutch Plate and Hub Assembly Disassembly and Assembly: Disassembly

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.

Remove the compressor. Refer to Condenser Removal and Installation .
Install the compressor holding fixture J-34992 to the compressor and hold the compressor holding fixture using a bench vise.
Use the clutch hub holding tool J-33027 to keep the clutch drive plate and the hub assembly from turning.
Remove the shaft nut using the shaft nut socket J-33022.

Fig 1: Disassembling Clutch Plate And Hub Assembly (1 Of 2)
Courtesy of SUZUKI OF AMERICA CORP.
Thread the hub and drive plate remover J-33013-B into the hub. Hold the body of the remover with a wrench and turn the center screw into the remover body to remove the clutch drive plate and the hub assembly.
Remove the clutch hub key. Retain the key for assembly.

Fig 2: Disassembling Clutch Plate And Hub Assembly (2 Of 2)
Courtesy of SUZUKI OF AMERICA CORP.