Crankshaft Position (CKP) Sensor Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Suzuki Reno and 2005 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.

Insert the CKP sensor into the engine block.
Install the CKP sensor retaining bolt.
Tighten

Tighten the crankshaft position sensor retaining bolt to 8 N.m (71 lb-in).
Connect the CKP sensor connector.
Install the accessory mounting bracket with the bolts.
Tighten

Tighten the accessory mounting bracket bolts to 37 N.m (27 lb-ft).

Fig 1: Installing Accessory Mounting Bracket With Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Install the rear A/C mounting bracket.
Tighten

Tighten the rear A/C mounting bracket bolts to 35 N.m (26 lb-ft).
Install the A/C compressor. Refer to "COMPRESSOR REMOVAL AND INSTALLATION :"
Install the power steering pump. Refer to "PUMP ASSEMBLY REMOVAL AND INSTALLATION :"
Connect the negative battery cable.

Fig 2: Installing Rear A/C Mounting Bracket
Courtesy of SUZUKI OF AMERICA CORP.