LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Engine Electrical Devices) >> Repair Instructions >> Camshaft Position Sensor Removal and Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Camshaft Position Sensor Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Suzuki Reno and 2005 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the camshaft position sensor and bolts.

    Tighten 

    Tighten the camshaft position bolts to 8 N.m (71 lb-in).

    Fig 1: Installing Camshaft Position Sensor And Bolts
    G04102630Courtesy of SUZUKI OF AMERICA CORP.
  2. Install the timing belt front cover, the crankshaft pulley, the accessory drive belt, and the air filter. Refer to "TIMING BELT REMOVAL AND INSTALLATION :"
  3. Connect the sensor electrical connector.
  4. Install the engine cover.
  5. Connect the negative battery cable.
    Fig 2: Installing Engine Cover
    G04102631Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals