DTC 07: Steering Wheel Speed Sensor Short to 5 V: Troubleshooting
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
TROUBLESHOOTING REFERENCE
| Step | Action | Value (s) | Yes | No |
|---|---|---|---|---|
| 1 | Did you perform the Variable Effort Steering Diagnostic System Check? | - | Go to Step 2 | Go to DIAGNOSTIC SYSTEM CHECK-VARIABLE EFFORT STEERING |
| 2 |
Is the measured resistance within the specified value? |
4.8 - 5.2 V | Go to Step 3 | Go to Step 8 |
| 3 |
Is the resistance ∞ Ω? |
∞ Ω | Go to Step 4 | Go to Step 6 |
| 4 | Check the resistance between the terminal 14 and 5 of the SSPS control module wiring harness. Is the resistance ∞Ω? |
∞Ω | Go to Step 5 | Go to Step 6 |
| 5 | Check the resistance between the terminal 3 and 5 of the SSPS control module wiring harness. Is the resistance ∞Ω? |
∞Ω | Go to Step 7 | Go to Step 6 |
| 6 | Replace the wiring. Is the repair completed? |
- | Go to Step 9 | - |
| 7 | Replace the SSPS control module. Is the repair complete? |
- | Go to Step 9 | - |
| 8 | Replace the steering wheel speed sensor. Is the repair complete? |
- | Go to Step 9 | - |
| 9 | Operate the system in order to verify the repair. Did you correct the condition? |
- | System OK | Go to Step 2 |