LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Manual Transmission) >> Repair Instructions >> Transaxle Assembly Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Transaxle Assembly Removal and Installation: Removal

WARNING: This page is about a different car, the 2007 Suzuki Reno, 2007 Suzuki Forenza, 2006 Suzuki Reno, and 2006 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the engine assembly support fixture DW110-060.
  2. Remove the battery and battery tray. Refer to BATTERY AND BATTERY TRAY REMOVAL AND INSTALLATION .
  3. Remove the shift linkage assembly. Refer to Shift Linkage Assembly Removal and Installation .
  4. Remove the drive axle shaft. Refer to DRIVE AXLE ASSEMBLY REMOVAL AND INSTALLATION .
    Fig 1: Identifying Shift Linkage Assembly
    G04717421Courtesy of SUZUKI OF AMERICA CORP.
  5. Disconnect the backup lamp switch electrical connector.
  6. Disconnect the speedometer speed sensor electrical connector.
    Fig 2: Locating Speedometer Speed Sensor Electrical Connector
    G04717422Courtesy of SUZUKI OF AMERICA CORP.
  7. Remove the pin and the clutch release cylinder pipe.
    Fig 3: Identifying Pin And Clutch Release Cylinder Pipe
    G04717423Courtesy of SUZUKI OF AMERICA CORP.
  8. Remove the damping block connection nut and bolt.
  9. Remove the three rear mounting bracket bolts.
  10. Remove the rear mounting bracket from the transaxle.
    Fig 4: Identifying Rear Mounting Bracket Bolts
    G04717424Courtesy of SUZUKI OF AMERICA CORP.
  11. Remove the two rear damping block retaining bolts.
  12. Remove the rear damping block from the front cross member.
    Fig 5: Identifying Rear Damping Block Retaining Bolts
    G04717425Courtesy of SUZUKI OF AMERICA CORP.
  13. Remove the two cage retaining bolts.
  14. Remove the three transaxle upper mounting bracket bolts.
  15. Remove the upper mounting bracket and cage.
    Fig 6: Identifying Transaxle Upper Mounting Bracket Bolts
    G04717426Courtesy of SUZUKI OF AMERICA CORP.
  16. Remove the three transaxle upper retaining bolts.
    Fig 7: Identifying Transaxle Upper Retaining Bolts
    G04717427Courtesy of SUZUKI OF AMERICA CORP.
  17. Support the transaxle with a transaxle support jack.
    Fig 8: Supporting Transaxle
    G04717428Courtesy of SUZUKI OF AMERICA CORP.
  18. Remove the seven transaxle lower retaining bolts.
    Fig 9: Identifying Transaxle Lower Retaining Bolts
    G04717429Courtesy of SUZUKI OF AMERICA CORP.
  19. Remove the transaxle.
  20. Slide the transaxle sideways away from the engine block.
  21. Lower the transaxle.
    Fig 10: Supporting Transaxle
    G04717430Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals