LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Steering Wheel And Column) >> Repair Instructions >> Steering Wheel Speed Sensor Removal and Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Wheel Speed Sensor Removal and Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the steering wheel speed sensor with the retaining screw.

    Tighten: 

    Tighten the steering wheel speed sensor retaining screw to 2 N.m (18 lb-in).

    Fig 1: Identifying Retaining Screw And Steering Wheel Speed Sensor
    G04717641Courtesy of SUZUKI OF AMERICA CORP.
  2. Install the intermediate shaft onto the steering column. Refer to INTERMEDIATE SHAFT AND DASH SEAL REMOVAL AND INSTALLATION .
  3. Connect the steering wheel speed sensor electrical connector.
  4. Install the upper and the lower instrument trim panels. Refer to INSTRUMENT CLUSTER TRIM PANEL REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable.
    Fig 2: Identifying Steering Wheel Speed Sensor Electrical Connector
    G04717643Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals