Hub and Bearing Disasembly and Assembly: Assembly

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.

Insert the threaded rod CH-46560-04 through the bearing CH-46560-06, Wheel Bearing Spacer CH-48835, wheel bearing and knuckle.

Fig 1: Installing Wheel Bearing Installation Tools
Courtesy of SUZUKI OF AMERICA CORP.
Place the Wheel Bearing Spacer CH-48834 and nut CH-46560-05 on the rod CH-46560-04.
Hand-tighten the nuts and install the wheel bearing in the knuckle.

Fig 2: Installing Wheel Bearing Installation Tools

Courtesy of SUZUKI OF AMERICA CORP.

Remove all the special tools from the knuckle.
Install the retaining ring.
Insert the threaded rod CH-46560-04 through the bearing CH-46560-06, Wheel Bearing Spacer CH-46560-03, wheel hub and knuckle.
Place the Wheel Bearing Spacer CH-48834 and nut CH-46560-05 on the rod CH-46560-04.

Fig 3: Placing Wheel Bearing Spacer CH-48834 and Nut (CH-46560-05) On Rod (CH-46560-04)

Courtesy of SUZUKI OF AMERICA CORP.

Hand-tighten the nuts and install the wheel hub.
Remove all the special tools from the knuckle assembly.