LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Front Suspension) >> Repair Instructions >> Control Arm Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Arm Removal and Installation: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and suitably support the vehicle. Let the control arms hang free.
  2. Remove the wheel. Refer to WHEEL REMOVAL AND INSTALLATION .
  3. Remove the pinch bolt and the nut from the ball joint.
  4. In case of right-hand side, remove the engine mounting.
    Fig 1: Identifying Ball Joint Pinch Bolt And Nut
    G04716784Courtesy of SUZUKI OF AMERICA CORP.
  5. Disconnect the ball joint from the knuckle assembly using the ball joint remover KM-507-B.
    Fig 2: Identifying Ball Joint Remover KM-507-B
    G04716799Courtesy of SUZUKI OF AMERICA CORP.
  6. Remove the control arm-to-crossmember bolts.
  7. Remove the control arm from the vehicle.
    Fig 3: Identifying Control Arm-To-Crossmember Bolts
    G04716800Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals