LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Engine Lubrication System) >> Repair Instructions >> Oil Pump Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Oil Pump Removal and Installation: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the timing belt. Refer to TIMING BELT REMOVAL AND INSTALLATION .
  3. Remove the rear timing belt cover. Refer to REAR TIMING BELT COVER REMOVAL AND INSTALLATION .
  4. Disconnect the oil pressure switch connector.
    Fig 1: Identifying Oil Pressure Switch Connector
    G04716577Courtesy of SUZUKI OF AMERICA CORP.
  5. Remove the oil pan. Refer to Oil Pan Removal and Installation .
  6. Remove the oil suction pipe and support bracket bolts.
  7. Remove the oil suction pipe.
    Fig 2: Identifying Oil Suction Pipe And Support Bracket Bolts
    G04716480Courtesy of SUZUKI OF AMERICA CORP.
  8. Remove the oil pump retaining bolts.
  9. Carefully separate the oil pump and gasket from the engine block and oil pan.
  10. Remove the oil pump.
    Fig 3: Identifying Oil Pump, Retaining Bolts And Gasket From Engine Block And Oil Pan (1 Of 2)
    G04716595Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals