LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Engine Electrical Devices) >> Engine Electrical Devices >> Throttle Body Removal and Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Throttle Body Removal and Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Use care in cleaning old gasket material from machined aluminum surfaces. Sharp tools may damage sealing surfaces.
  1. Clean the gasket mating surface on the intake manifold.
  2. Clean the throttle body.
  3. Install the throttle body assembly with a new gasket to the intake manifold.
  4. Install the throttle body retaining nuts.

    Tighten: 

    Tighten the throttle body retaining nuts to 10 N.m (89 lb-in).

  5. Connect the ETC connector.
  6. Connect the coolant hoses to the throttle body.
  7. Connect the vacuum hoses to the throttle body.
  8. Install the air intake tube.
  9. Connect the breather hose to the valve cover.
  10. Connect the IAT sensor connector.
  11. Connect the negative battery cable.
  12. Fill the cooling system.
scientia non olet · About LEMON Manuals