Engine Mount Removal and Installation: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.

Install the engine mount.
Install the engine mount retaining bolts.
Tighten:

Tighten the engine mount retaining bolts to 45 N.m (33 lb-ft).

Fig 1: Identifying Engine Mount Retaining Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Install the timing belt idler pulleys.
Install the timing belt idler pulley bolt and nut.
Tighten:

Tighten the timing belt idler pulley bolt and nut to 25 N.m (18 lb-ft).
Tension the timing belt by turning the timing belt automatic tensioner hex-key tab counterclockwise until the pointer is aligned to the indicator.
Tighten:

Tighten the timing belt automatic tensioner bolt to 25 N.m (18 lb-ft).

Fig 2: Identifying Timing Belt Automatic Tensioner Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install the front timing belt cover.
Install the front timing belt cover bolts.
Tighten:

Tighten the front timing belt cover bolts to 6 N.m (53 lb-in).
Install the engine mount bracket and retaining bolts.
Tighten:

Tighten the engine mount bracket retaining bolts to 55 N.m (41 lb-ft).
Remove the engine assembly support fixture DW110-060.
Install the serpentine accessory drive belt. Refer to SERPENTINE ACCESSORY DRIVE BELT REMOVAL AND INSTALLATION .
Connect the negative battery cable.

Fig 3: Identifying Front Timing Belt Cover
Courtesy of SUZUKI OF AMERICA CORP.