Surge Tank Cap Test
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
Tools Required:
KM-471 Adapter
The surge tank cap maintains proper pressure, protects the system from high pressure by opening a pressure valve, and protects the coolant hoses from collapsing because of a vacuum.
- Wash any sludge from the surge tank cap and the valve seat of the vacuum pressure valve for the surge tank cap.
- Check for any damage or deformity to the vacuum pressure valve for the surge tank cap. If any damage or deformity is found, replace the cap.
- Install a suitable cooling system pressure tester to the cap using the adapter KM-471.
- Pull the vacuum pressure valve open. If the surge tank cap does not seal properly, replace the surge tank cap.
- Pressurize the cap to 90 - 120 kPa (13.1 - 17.4 psi).
- Wait 10 seconds and check the pressure held by the tank cap tester.
- If the pressure held by the cooling system pressure tester falls below 80 kPa (11.6 psi), replace the surge tank cap.