LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Fuel System) >> Repair Instructions >> Fuel Pump Removal and Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Pump Removal and Installation: Removal

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 Suzuki Reno, 2008 Suzuki Forenza, 2007 Suzuki Reno, 2007 Suzuki Forenza, and 2006 Suzuki Reno. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: The fuel system is under pressure. To avoid fuel spillage and the risk of personal injury or fire, it is necessary to relieve the fuel system pressure before disconnecting the fuel lines.
  1. Relieve the fuel system pressure.
    1. Remove the fuel cap.
    2. Remove fuel pump fuse Ef18 from the engine fuse block.
    3. Start the engine and allow the engine to stall.
    4. Crank the engine for an additional 10 sec.
      Fig 1: Identifying Fuel Pump Access Cover
      G04716646Courtesy of SUZUKI OF AMERICA CORP.
  2. Disconnect the negative battery cable.
  3. Remove the rear seat. Refer to REAR SEAT CUSHION REMOVAL AND INSTALLATION .
  4. Remove the fuel pump access cover.
  5. Disconnect the electrical connector at the fuel pump assembly.
  6. Disconnect the fuel line.
    Fig 2: Identifying Electrical Connector At Fuel Pump Assembly
    G04716647Courtesy of SUZUKI OF AMERICA CORP.
  7. Remove the fuel pump assembly clip.
  8. Remove the fuel pump assembly from the tank.
    Fig 3: Identifying Fuel Pump Assembly In Tank
    G04716661Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals