Control Valve Body Assembly Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Suzuki Reno and 2005 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.

Tilt the valve body.
Install the output speed sensor mounting bolt.
Tighten

Tighten the output speed sensor mounting bolt to 6 N.m (53 lb-in).

Fig 1: Installing Output Speed Sensor Mounting Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install the control valve body and the bolts.
Tighten

Tighten the valve body mounting bolts to 8 N.m (71 lb-in).
Install the input speed sensor mounting bolt.
Tighten

Tighten the input speed sensor mounting bolt to 8 N.m (71 lb-in).
Install the oil pan and oil pan gasket. Refer to "OIL PAN, OIL PAN GASKET REMOVAL AND INSTALLATION :".

Fig 2: Installing Input Speed Sensor Mounting Bolt
Courtesy of SUZUKI OF AMERICA CORP.
Install the transaxle fluid drain plug using the plug remove/installer DW260-070.
Install the engine under cover. Refer to "ENGINE UNDER COVERS REMOVAL AND INSTALLATION :".

Fig 3: Installing Transaxle Fluid Drain Plug
Courtesy of SUZUKI OF AMERICA CORP.
Lower the vehicle.
Connect the transaxle wiring harness and the PNP switch electrical connector.
Refill the transaxle fluid. Refer to "TRANSAXLE FLUID LEVEL CHECKING PROCEDURE :".
Connect the negative battery cable.

Fig 4: Identifying Transaxle Wiring Harness And PNP Switch Electrical Connector
Courtesy of SUZUKI OF AMERICA CORP.