Temperature Control Cable Removal and Installation: Removal

WARNING: This page is about a different car, the 2005 Suzuki Reno and 2005 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the center molding. Refer to "CENTER MOLDING REMOVAL AND INSTALLATION :".

Fig 1: Removing Center Molding
Courtesy of SUZUKI OF AMERICA CORP.
Disconnect the mode control cable from the mode door.
Disconnect the temperature control cable eyelet from the post on the controller.
Pry off the clip of the temperature control cable.

Fig 2: Disconnecting Mode Control Cable From Mode Door
Courtesy of SUZUKI OF AMERICA CORP.
Slide the cable eyelet off the post on the temperature door lever.
Pry off the Clip of the temperature cable.

Fig 3: Prying Clip Of Temperature Cable
Courtesy of SUZUKI OF AMERICA CORP.