Steering Wheel Rotation Sensor Removal and Installation: Installation
WARNING: This page is about a different car, the 2005 Suzuki Reno and 2005 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.
- Install the steering wheel rotation sensor with the retaining screw.
Tighten
Tighten the steering wheel rotation sensor retaining screw to 2 N.m (18 lb-in).
- Install the intermediate shaft onto the steering column. Refer to "INTERMEDIATE SHAFT AND DASH SEAL REMOVAL AND INSTALLATION :".
- Connect the steering wheel rotation sensor electrical connector.
- Install the upper and the lower instrument trim panels. Refer to "INSTRUMENT CLUSTER TRIM PANEL REMOVAL AND INSTALLATION :".
- Connect the negative battery cable.