LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Brakes - Front) >> Repair Instructions >> Brake Pads Removal and Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Brake Pads Removal and Installation: Installation

WARNING: This page is about a different car, the 2005 Suzuki Reno and 2005 Suzuki Forenza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the minimum lining thickness. Refer to "BRAKE PADS INSPECTION :".
  2. Install the brake pads into the caliper.
  3. Push the piston inward, if needed.
    CAUTION: Take care not to damage the piston seal when the piston housing frame is pulled down.
  4. Pull down the caliper piston housing and secure it to the retaining frame with the lower bolt.

    Tighten 

    Tighten the retaining frame-to-caliper housing bolts to 27 N.m (20 lb-ft).

  5. Install the front wheels. Refer to "WHEEL REMOVAL AND INSTALLATION :".
  6. Lower the vehicle.
    CAUTION: Do not move the vehicle until a firm pedal is obtained, or improper braking action will result.
    Fig 1: Tightening Retaining Frame-To-Caliper Housing Bolts
    G04103300Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals