LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 170 (Wipers/Washers) >> Repair Instruction >> Windshield Wiper And Washer Switch Inspection >> Intermittent Wiper Relay Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Intermittent Wiper Relay Circuit

WARNING: This page is about a different car, the 2008 Suzuki Grand Vitara, 2007 Suzuki Grand Vitara, and 2006 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the windshield wiper switch to "INT" position.
  2. Connect battery positive (+) terminal to terminal "5" and its negative (-) terminal to terminal "2".
  3. Connect voltmeter positive lead to terminal "4" and its negative lead to terminal "2".
  4. Check that the voltmeter indicates the battery voltage (10 - 14 V).
  5. Connect terminal "3" and terminal "5" by a jumper wire.
    Fig 1: Intermittent Wiper Relay Circuit Diagram
    G04809824Courtesy of SUZUKI OF AMERICA CORP.
  6. Disconnect end of the jumper wire from terminal "5".
  7. Connect disconnected jumper wire end to terminal "2", then check that voltage between terminal "4" and terminal "2" changes as shown.

    If check result is not satisfied, replace switch.

    Fig 2: Checking Voltage Between Terminals No. 2 & 4
    G04809825Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals