LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 (Steering Wheel And Column) >> Repair Instructions >> Steering Column Assembly Removal And Installation >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Steering Column Assembly Removal And Installation: Removal

WARNING: This page is about a different car, the 2008 Suzuki Grand Vitara, 2007 Suzuki Grand Vitara, and 2006 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Never rest a steering column assembly on the steering wheel with air bag (inflator) module face down and column vertical. Otherwise personal injury may result.
CAUTION: Never turn steering wheel while steering column with steering wheel is removed. Turning steering wheel more than about two and a half turns will break contact coil cable assembly.
  1. Disconnect negative (-) cable at battery.
  2. Disable air bag system. Refer to DISABLING AIR BAG SYSTEM (ADVANCED AIR BAG) or DISABLING AIR BAG SYSTEM (EXCEPT ADVANCED AIR BAG) .
  3. Remove steering wheel and contact coil cable assembly. Refer to STEERING WHEEL REMOVAL AND INSTALLATION  and CONTACT COIL CABLE ASSEMBLY REMOVAL AND INSTALLATION .
  4. Remove instrument panel under cover (1) from instrument panel.
    Fig 1: Identifying Instrument Panel Under Cover
    G04809080Courtesy of SUZUKI OF AMERICA CORP.
  5. Remove immobilizer control module (ICM) referring to IMMOBILIZER CONTROL MODULE (ICM) REMOVAL AND INSTALLATION .
  6. Remove lighting switch. Refer to LIGHTING SYSTEMS .
  7. Remove washer switch referring to WINDSHIELD WIPER AND WASHER SWITCH REMOVAL AND INSTALLATION .
  8. Disconnect connector from steering lock assembly.
  9. For A/T vehicle, disconnect shift (key) interlock cable (1) from ignition switch with ignition switch turned at ACC position.

    After disconnecting, turn ignition switch to LOCK position.

    Fig 2: Identifying Shift (Key) Interlock Cable
    G04809081Courtesy of SUZUKI OF AMERICA CORP.
  10. Remove steering upper shaft upper joint bolt (1) and nut (2).
    Fig 3: Identifying Steering Upper Shaft Upper Joint Bolt & Nut
    G04809082Courtesy of SUZUKI OF AMERICA CORP.
  11. Remove column support bracket. (if equipped)
  12. Remove steering column assembly (1) mounting bolts (2) and nuts (3).
    NOTE: Do not move tilt lever before till mounting bolts and nuts are tightened completely.
    Fig 4: Identifying Steering Column Assembly Mounting Bolts & Nuts
    G04809083Courtesy of SUZUKI OF AMERICA CORP.
  13. Remove steering column assembly from vehicle.
scientia non olet · About LEMON Manuals