Output Shaft Speed Sensor Removal And Installation: Installation
WARNING: This page is about a different car, the 2006 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.
- Check that sensor is free from any metal particles and damage.
- Apply A/T fluid to new O-ring and then install output shaft speed sensor (1) to transmission.
Tighten sensor bolt to specified torque .
Tightening torque
Output shaft speed sensor bolt a: 5.5 N.m (0.55 kg-m, 4.0 lb-ft)
- Connect output shaft speed sensor connector.
- Lower hoist.
- Connect negative cable at battery.