Split Rear Seatback Installation

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent premature corrosion.

Install the seatback to the hinges with the bolts and the nuts.
Tighten:
- Tighten the rear seatback bolts to 25 N.m (18 lb-ft).
- Tighten the rear seatback nuts to 25 N.m (18 lb-ft).
Install the rear seatback backside cover with the retaining clips.
Raise and secure the rear seatbacks in the upright position.

Fig 1: Removing/Installing Seatback Hinges, Nuts And Bolts
Courtesy of SUZUKI OF AMERICA CORP.