LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 114 (Wipers/Washers) >> Diagnostic Information & Procedures >> 2-Speed Intermittent Windshield Wipers Diagnosis >> Windshield Wipers Do Not Work at Any Speed
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Windshield Wipers Do Not Work at Any Speed

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.
DIAGNOSIS REFERENCE CHART - WINDSHIELD WIPERS DO NOT WORK AT ANY SPEED

Step Action Value(s) Yes No
1 Check fuse F17.
Is fuse F17 blown?		 - Go to Step 2 Go to Step 3
2
  1. Check for a short circuit and repair it, if necessary.
  2. Replace the fuse.

Is the repair complete?		 - System OK -
3 Check the voltage at fuse F16 and F17.
Is the voltage equal to the specified value?		 11 - 14 V Go to Step 5 Go to Step 4
4 Repair the open power supply circuit to fuse F16 and F17.
Is the repair complete?		 - System OK -
5
  1. Disconnect the wiper motor connector.
  2. Turn the ignition ON.
  3. Turn the wiper switch to HI.
  4. Check the voltage at the wiper motor connector terminal 6.

Is the voltage equal to the specified value?		 11 - 14 V Go to Step 6 Go to Step 7
6 Replace the wiper motor.
Is the repair complete?		 - System OK -
7
  1. The wiper switch is still disconnected.
  2. Turn the ignition ON.
  3. Check for battery voltage at the wiper switch connector terminal A8.

Is the voltage equal to the specified value?		 11 - 14 V Go to Step 9 Go to Step 8
8 Repair the open circuit between the wiper switch connector terminal A8 and fuse F17.
Is the repair complete?		 - System OK -
9
  1. The wiper switch is still disconnected.
  2. Turn the wiper switch to HI.
  3. Use an ohmmeter to check for continuity between the wiper switch connector terminal A8 and A9.

Does the ohmmeter indicate the specified value?		 0 Ω Go to Step 11 Go to Step 10
10 Replace the wiper switch.
Is the repair complete?		 - System OK -
11 Repair the open circuit between the wiper switch and the wiper motor.
Is the repair complete?		 - System OK -
scientia non olet · About LEMON Manuals