LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 110 (Air Conditioning System) >> Manual >> Repair Instructions >> A/C Suction Hose Assembly Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

A/C Suction Hose Assembly Removal

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Discharge and recover the refrigerant. Refer to Discharging, Adding Oil, Evacuating and Charging Procedures for A/C System .
  3. Remove the surge tank mounting screws.
  4. Remove the surge tank.
  5. Remove the retaining nut from the hose connecting block and disconnect the air conditioning (A/C) hose assembly connector block at the top rear of the compressor.
  6. Cap all of the openings to prevent contamination.
    Fig 1: Identifying Compressor Hose Connecting Block & Nut
    G04718908Courtesy of SUZUKI OF AMERICA CORP.
  7. Remove the suction hose support clamp bolt and the clamp along the left side of the engine compartment fender well.
  8. Remove the evaporator flange connecting block retaining nut and disconnect the A/C suction hose at the fire wall evaporator flange connecting block. Discard the O-ring seal.
  9. Remove the A/C suction hose.
  10. Cap the opening to the evaporator flange to prevent contamination.
    Fig 2: Identifying A/C Suction Hose, Support Clamp & Bolt
    G04720007Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals