LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Suzuki >> 2007 >> SX4 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 109 (Heater And Ventilation) >> Repair Instructions >> Control Assembly Knob Lighting Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Assembly Knob Lighting Installation

WARNING: This page is about a different car, the 2006 Suzuki Verona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the bulb into the holder and turn the bulb to the right.
  2. Install the control assembly case halves.
    • Pass the connector for the vacuum switch through the hole in the rear assembly case part.
    • Be sure to align the flats on mating control shafts of the 2 case halves.
  3. Install the connector into the vacuum control switch.
    Fig 1: Identifying Vacuum Control Switch
    G04720774Courtesy of SUZUKI OF AMERICA CORP.
  4. Install the control assembly. Refer to Control Assembly Installation .
  5. Connect the negative battery cable.
  6. Check the knob light for proper operation.
    Fig 2: Identifying Control Assembly
    G04720775Courtesy of SUZUKI OF AMERICA CORP.
scientia non olet · About LEMON Manuals