Transmission Shift Control Lever Removal And Installation: Installation

WARNING: This page is about a different car, the 2008 Suzuki Grand Vitara, 2007 Suzuki Grand Vitara, and 2006 Suzuki Grand Vitara. However, it is still accessible from the selected car via links, so may be relevant.

Reference: TRANSMISSION SHIFT CONTROL LEVER INSPECTION

Tighten new control lever locating bolts (1) to specified torque, if removed.
Tightening torque

Control lever locating bolt a: 10 N.m (1.0 kg-m, 7.5 lb-ft)
Apply grease to pivot portions and seat, then install shift control lever.
"A": Grease 99000-25010SUZUKI Super Grease A

Fig 1: Identifying Control Lever Locating Bolts
Courtesy of SUZUKI OF AMERICA CORP.
Set shift control lever (2) to gear shift lever rear case.
Install case cover (1) to gear shift lever rear case (3). Tighten case cover bolt to specified torque.
Tightening torque

Case cover bolt a: 10 N.m (1.0 kg-m, 7.5 lb-ft)

Fig 2: Identifying Case Cover & Gear Shift Lever Rear Case
Courtesy of SUZUKI OF AMERICA CORP.
Install sheet, boot (1) with boot cover (2) to floor panel.
Tightening torque

Control lever boot cover bolt a: 12 N.m (1.2 kg-m, 9.0 lb-ft)

Fig 3: Identifying Sheet, Boot With Boot Cover
Courtesy of SUZUKI OF AMERICA CORP.
Install front console box referring to CONSOLE BOX COMPONENTS .